Why does my TV Guide say no data?

Why does my TV Guide say no data?

When your Guide shows “No Data”, it means that the guide information is still loading. This is a normal behaviour when: You just activated your receiver. You just plugged your receiver back.

Why is my Cox TV Guide not working?

If the guide still isn’t appearing, or if no guide appears after pressing the Cable button then guide on the Cox Universal remote, then I would recommend unplugging the power to the receiver for 20 seconds. Once the reset is complete, please try following through with the Cox Universal remote steps again.

Why does my optimum guide say no data?

If your cable box states “No Data Available” on your program guide, disconnect the power from the box for about 30 seconds. Plug the box back up and wait for the time to appear on the front of the box before turning the power to the box back on. This should refresh the program guide data to the box.

Why does my Cox guide say program unavailable?

That can possibly indicate a signal issue. If you have already checked the coaxial cable connections/bypassed any possible splitters and rebooted the cable box, then we may need to have a technician out. Send us an email to [email protected] if you need us to setup a service call.

What do you do when your TV guide says to be announced?

If you are still seeing the “To Be Announced” messages for longer than a day on every channel, power cycle the cable box by unplugging it’s power cable for 30 seconds and then plugging it back in.

Why does my Cox Cable Guide say to be announced?

The Cox moderators said to unplug the DVR for 2 minutes. When you re-plug, the “To be announced” should disappear but it might take 10 to 60 minutes. The regular tv guide will appear.

Why is my guide not working?

Make sure your remote control is in the correct source mode. Press the CBL button on your remote control and then press the Guide or Menu button again. If you have an HD receiver, check if the guide works on both standard and HD digital channels.

Why is my cable guide not working?

Change the channel filters on your guide. If the issue continues, reboot your receiver by unplugging the power cord and allow at least 60 seconds before plugging it back in. Allow at least 20 minutes for the receiver to fully recover and turn it back on.