News

What size is Mercury fuel line?

What size is Mercury fuel line?

Mercury/Mariner O/B Standard Fuel Line Assembly, 6′ x 3/8″

Compatibility 93806BLP7
Inside Diameter 3/8 Inch
Outside Diameter 11/16 Inch
Maximum Continuous Length 6 Foot
Type Fuel Tank Lines

Do Mercury and Yamaha fuel connectors the same?

Compatibility: for all Yamaha (Engine and Fuel Tank Connection) and All Mercury Engine Connection (Apply connector to Engine only). In Addition, will fit original mercury fuel tank connection up to 1998.

How do you hook up a fuel line to a kicker motor?

You can add a fuel line to the other (basically, screw out the plug, screw in a fuel barb, add a line with fuel bulb then a connector on the other end to connect to the kicker).

How do you prime a outboard fuel line?

Simply turn the key to the “run” position and wait. You’ll hear a beep, followed by the sound of the fuel pump running. In just a few seconds the pump will clear the air out of the fuel line, and you’ll be ready to start it up.

How do I calculate fuel line size?

If your pump does not list line sizes, use the table below as a basic guideline….Recommended Size, Based on Horsepower.

Recommended Fuel Line Size (from the tank to the pump)
Engine Output Size (inches) Size (AN)
350 hp or less 5/16 in. -5
350-450 hp 3/8 in. -6
450-650 hp 1/2 in. -8

How much horsepower will a 5/16 fuel line support?

If you’re just cruising around with a carbed SBC, you’ll probably be fine with a 5/16″ line up to about 500 HP because you’ll never tax the system enough to starve the motor of fuel.

Will a Yamaha fuel connector fit a mercury?

Yamaha Outboard Fuel Line Assembly Will also fit Mercury & Mariner outboards which require the tank end to push on to 8-10mm barbed fuel fitting. Please note engine end connector will only fit Mercury Mariner engine 1987 & Newer. 5/16″ ID Hose is compatible with most outboard engine fuel systems.

Are Evinrude and Yamaha fuel connectors the same?

Please make sure that you are posting in the form of a question. Please enter a question. Answer: I think you’ll find that the Yamaha and Evinrude fuel connectors are similar but not interchangeable.

How do you prime a new outboard fuel line?

How do you connect fuel lines from a kicker outboard to the main fuel line?